Description

A diamond whetstone is a tool used for grinding and trimming tools. It is usually made of diamond particles. Diamond is an extremely hard material with high wear resistance and grinding properties.The use of diamond whetstone can effectively sharpen and repair the edge of the tool to make it sharper. Diamond whetstones have different particle sizes. The finer the particle size, the finer the grinding effect of the whetstone.When using diamond whetstone, it is necessary to choose the appropriate particle size according to the type of tool and the degree of wear. Diamond Sharpening whetstone is widely used in cooking, lawn and garden, woodworking and carving, speed skating, skiing, camping, fishing, hunting、 The method of using diamond whetstone is as follows： 1. Preparation: Place the diamond whetstone on a smooth workbench and make sure that the surface of the whetstone is clean. 2. Moisten the whetstone: Use the right amount of water to moisten the surface of the whetstone, but not too much, so as not to affect the grinding effect. 3. Place the tool: Place the edge of the tool on the whetstone at an angle (usually 15-20 degrees) to the whetstone, and make sure that the edge is in contact with the whetstone. 4. Sharpen the edge: Use appropriate pressure to slowly move the tool back and forth on the whetstone to maintain a stable grinding action.The intensity and frequency of grinding can be adjusted as needed. 5. Regular inspection: Check the edge of the tool from time to time to ensure uniform grinding.If uneven or defective areas are found, targeted grinding can be carried out. 6. Turning grinding: When one side of the grinding is completed, the other side of the whetstone can be turned over for grinding to obtain a more uniform grinding effect. 7. Cleaning and maintenance: After use, clean the surface of the whetstone to remove metal shavings and dirt from grinding.Regular maintenance of the whetstone to ensure its performance and life. (1) 4pcs Sharpening stones set, Made of durable diamond material,Electroplating and spraying process is adopted.Uniform particles and flat surface. (2) Coarse Stone 80# - Diamond has a large particle size and a rougher surface. It is suitable for rapid cutting and grinding, removing impurities and repairing defects. (3)Medium Stone 320# - The 320 Grit whetstone is relatively fine and can be used to remove minor scratches and passivate the blade to make it sharper.It is suitable for further trimming and polishing tools that have been ground to a certain extent. (4)Medium Stone 500# - The use of a 500 Grit whetstone can effectively remove tiny scratches and burrs on the blade, making the tool sharper.It is suitable for tools that have been preliminarily ground, or tools that need to be finely trimmed. (5)Fine Stone 1000# -The 1000 Grit whetstone is a very fine sharpening tool, suitable for the ultimate polishing and trimming of the tool. The use of a 1000 grit whetstone can obtain an extremely smooth edge, so that the sharpness and finish of the tool can reach a higher level.It is usually used in the final polishing stage to remove fine scratches and blemishes, making the blade sharper and brighter. (6)Size Information 150x62mm (5.98"x2.44") It is compact and lightweight, suitable for use outdoors, when traveling or when you need to sharpen your knife at any time. (7)Use for:grinding stone,jade,seal carving knife,wood crafts, metal grinder workpiece etc.